Details

---

Water Suction Hose 10 Bar Overview

Water Suction Hose 10 Bar is a hardwall rubber hose listed for suction of water and non-corrosive fluids in agricultural, industrial and general transfer duties. Its helix-wire-supported construction helps the hose resist collapse under suction. Final selection must match the fluid, hose size, working pressure, vacuum, temperature, fittings and pump conditions.

Published Hose Construction

• Tube: black SBR blend compound.
• Cover: black NR blend compound described as resistant to abrasion and weather.
• Reinforcement: multiple layers of high-tensile synthetic cord with helix wire support.
• Published temperature range: -20°C to +70°C.
• Published safety factor: 3:1.

Understanding the 10 Bar Product Designation

The 10 bar wording identifies the product range but does not automatically approve every hose size or complete assembly for 10 bar service. Confirm the current size-specific pressure data, discharge pressure where applicable, pump shut-off pressure, surges, fittings and assembly method.

The Complete Assembly Determines the Limit

The allowable pressure is governed by the lowest-rated hose, coupling, clamp, ferrule, flange, gasket or adapter. A published safety factor is not the permitted working pressure.

Water and Fluid Compatibility Review

State the exact fluid, treatment chemicals, suspended solids, salinity, oils or contaminants. “Non-corrosive fluid” is a general description and does not confirm compatibility with every mixture. Provide an SDS where the fluid contains chemicals or additives.

Suction, Vacuum and Collapse Resistance

The allowable vacuum depends on hose size, temperature, bend, length and construction. No universal vacuum rating is claimed on this page; confirm the size-specific value for the exact hose and avoid conditions that can collapse or flatten the hose.

Check Suction Lift and Pump Conditions

Provide suction lift, pump type, expected flow and inlet arrangement. Excessive restriction, blocked strainers, sharp bends or undersized hose can reduce pump performance and increase stress on the assembly.

Connections and Installation

Confirm hose bore, overall length, fitting or flange standard, material, clamp method and orientation. Use airtight connections on the suction side, route the hose with adequate bend radius, and support it without crushing or loading the fittings.

Prevent Kinks and External Damage

Keep the hose away from sharp edges, vehicle traffic, hot surfaces and excessive movement. Do not force the helix-reinforced hose into a tighter bend than the verified minimum.

Inspection and Safe Operation

Before use, inspect for cover cuts, soft spots, exposed reinforcement, broken helix wire, kinks, crushed areas, leakage or loose fittings. Before handling, stop and isolate the pump, close valves where applicable, and release trapped pressure or vacuum.

Remove a damaged assembly from service for competent assessment. Do not attempt an improvised repair on a hose with structural or wire damage.

Information Required for an Engineering Review

• Exact fluid, additives, contamination and SDS where applicable
• Working pressure, pump shut-off pressure and surge conditions
• Required vacuum, suction lift and pump type
• Flow requirement, hose bore and overall length
• Fluid and ambient temperature range
• Connection type, size, material and clamp method
• Routing, bend, movement, abrasion and traffic conditions
• Required testing, identification and documentation

Send these details to Advtech Engineering for a configuration review. Confirm the exact water suction hose and complete assembly against actual operating conditions before installation.